Search results

The article presents the results of research on the efficiency of the electric energy storage system in traction power supply on the example of one of the sections of JSC "Russian Railways". The results of measurements of electric values of electric rolling stock when moving along the railway section under study are considered. Based on simulation modeling, an assessment of the impact of power storage systems on the capacity of the railway section is obtained. Graphs of changes in the minimum travel interval and the minimum voltage on the current collector of an electric moving train depending on the power of the storage system, energy intensity, and threshold voltages for charge and discharge modes are constructed. An algorithm for the operation of the power storage system at a traction substation or linear device has been developed. Based on the simulation results, a graph of the degree of charge is constructed and a series characteristic is determined that allows maintaining the discharge depth at the level of no more than the specified one. Based on the results of calculations, the power, energy intensity and charging characteristics of the storage system are determined, which provide the required voltage level at the current receiver of an electric moving train within the boundaries of interstation zones.

An increase in the speeds of the electric rolling stock has an impact on the energy indicators of the operation of the traction power supply system. One of the technical solutions to the task of equalizing the traction load schedule to reduce voltage losses in the contact network is the use of electricity storage systems. The article presents the results of simulation modeling, which allow us to estimate the change in the energy indicators of an electric train with an increase in movement speeds for conditions of a single electric train following a section. According to the results of traction calculations, the influence of the voltage level on the electric train current collector on the technical speed is shown, the deviation of which for the typical voltage values in high-speed traffic is about 1%. For the selected section of rapid movement and technical speeds, the voltage level for traction calculations is justified. The dependences of the change in the average values of the load and the technical speed with an increase in the maximum speed up to 250 km/h are determined. Statistical estimates for the voltage on the pantograph of the Velaro RUS electric train are determined. The influence of the energy intensity of the onboard storage system with the corresponding charging characteristic on the reduction of maximum currents is shown. Dependences are obtained for the voltage drop on the electric train current collectors with an increase in movement speeds. The assessment of the maximum energy intensity of storage devices for the most severe operating conditions with a single electric train track on the site was carried out. These results allow us to determine the prospects for improving the method of calculating energy indicators and the use of accumulation systems in areas of rapid movement as on-board systems and compare their effectiveness with stationary systems based on simulation modeling, in which various control algorithms are implemented.

One of the properties of the reliability of the power supply of electric rolling stock of railways is the trouble-free operation of the traction power supply system in various modes of its operation. For post-emergency and forced modes of operation of the traction power supply system, a decrease in load capacity is characteristic. In order to ensure the throughput and carrying capacity of the railway section by traction power supply devices, it is proposed to consider the use of electric power storage devices on electric rolling stock and in the traction power supply system. Studies conducted by domestic and foreign researchers allow us to evaluate the effectiveness of alternative solutions to improve the reliability of power supply, which include various options for the use of electric power storage devices on electric rolling stock and in the traction power supply system. This article presents the results of a review of these solutions, a simulation model of a traction power supply system and an electric rolling stock with power storage devices based on various batteries and a supercapacitor is proposed. Modeling of changes in the modes of operation of the traction power supply system is carried out taking into account the state control of switching devices. The calculation results allow us to estimate the voltage drop at the output of electric power storage devices, including taking into account the exponential zone of the discharge characteristics of batteries, to estimate the voltage change for a given electric traction load depending on the energy intensity of the storage device, made on the basis of the most common types of batteries and a supercapacitor.